Pictures from the 54 Chevy.

This picture was taken quite a while ago, but it shows the pieces I had to add to fill in the holes that are left when making a tilt front end.

I had to fill in the front across the firewall as well as the sides of the firewall so you could not see inside the passengers compartment with the front end lifted.

You can also see, in the top picture, the hinge for the tilt at the very front of the frame.

Since these pictures were taken, the frame has been channeled, or recessed into the floor pan to lower the car more, and the front end has been radically lowered to improve the stance of the model.

There are some pictures I posted on an earlier post showing the difference between then and now. The frame is about a couple of sheets of paper's thickness off the ground now. I also had to narrow the front end to get it under the fenders by taking a slice out of the k frame and the tie rod ends as well.